A folding glass screen can open up the edge of a bathtub, but tape out where the glass will fold before you buy it. The stacked panels still need a place to sit. A vanity corner, faucet, towel bar, or window ledge can get in the way even when the screen fits the tub on paper.

Mark both positions on the tub
Pull up the installation diagram for the model you’re considering. Use painter’s tape to mark the wall mount and the edge the screen will cover when closed. Then mark where the panels swing and stack when open. Check the distance from the outside edge of the tub to the vanity and toilet, and try stepping in and out with the marked area in mind. If you bathe children or clean the tub from the side, check whether the folded screen leaves enough room to reach in.
Check the parts that need to meet
Read the product’s minimum tub ledge width and its requirements for the wall and mounting hardware. Measure the flat part of the ledge where the bottom seal will rest, since a curve or rounded lip can leave less usable space than it seems. Confirm which side the screen mounts on, whether the hinge is reversible, and where the shower spray will land. A partial screen leaves an open end, so consider the reach of the spray before choosing it for a narrow bathroom.
Finally, look at how you would clean the stacked panels and the seal. A setup that lets you unfold each section without moving a stool, hamper, or mat will be easier to wipe after use. The product photo shows the screen in one position. Your measurements show whether it can move through all the positions you need.
Take those notes with you when comparing models. Two screens sold for the same tub width can leave different amounts of room when folded.





Leave a Reply